CSS-80
齿轮类检测仪
小模数齿轮双面啮合综合测量仪
一,用途;
本仪器用于小模数圆柱齿轮进行双面啮合综合测量.按照GB2363-90<<小模数渐开线圆柱齿轮精度>>的规定.本仪器用于检测运动精度组指标中的径向综合误差,平稳性组指标中的径向一齿综合误差以及保证侧隙的双啮中心距偏差,用涂色法还可以检查接触斑点.
二,仪器的主要技术参数;
1.被测齿轮中心距------------------------------------------大于16-80毫米
2.被测齿轮最大直径------------------------------------------------80毫米
3.被测齿轮轴杆长度------------------------------------小于等于120毫米
4.仪器轮廓尺寸-----------------------------(长*宽*高)410*198*452毫米
5.仪器净重--------------------------------------------------------约25公斤
备注;1.,可根据用户需求,可提供增高70毫米的顶尖座.
2.可根据用户需求,可提供带孔齿轮的轴系附件.
Gear category Detector
Small-mesh gear double-sided integrated measuring instrument
一, use;
The equipment used for small module for double-sided cylinder gear meshing comprehensive measurement. Accordance with the GB2363-90 <<small module involute cylindrical gear precision>> requirements. The equipment used to detect movement precision set of indicators in the integrated radial Error, stable group of indicators in the teeth of a comprehensive radial error and to ensure that the backlash from the double-locked center deviation, and Tu-law also can check the contact spot.
二, apparatus, the main technical parameters;
1. Gear measured the distance ------------------------------------------ In the 16-80 mm
2. Gear measured maximum diameter ------------------------------------------- ----- 80mm
3. Gear shaft measured at length ------------------------------------ less than or equal to 120 mm
4. -----------------------------( Equipment size outline of long-* *) 410 * 198 * 452 mm
5. Apparatus NW ---------------------------------------------- ---------- About 25 kg
Note 1. According to user needs, can provide increased 70 mm at the top.
2. Based on user needs, can provide the gear shaft Hole annex.
Small-mesh gear double-sided integrated measuring instrument
一, use;
The equipment used for small module for double-sided cylinder gear meshing comprehensive measurement. Accordance with the GB2363-90 <<small module involute cylindrical gear precision>> requirements. The equipment used to detect movement precision set of indicators in the integrated radial Error, stable group of indicators in the teeth of a comprehensive radial error and to ensure that the backlash from the double-locked center deviation, and Tu-law also can check the contact spot.
二, apparatus, the main technical parameters;
1. Gear measured the distance ------------------------------------------ In the 16-80 mm
2. Gear measured maximum diameter ------------------------------------------- ----- 80mm
3. Gear shaft measured at length ------------------------------------ less than or equal to 120 mm
4. -----------------------------( Equipment size outline of long-* *) 410 * 198 * 452 mm
5. Apparatus NW ---------------------------------------------- ---------- About 25 kg
Note 1. According to user needs, can provide increased 70 mm at the top.
2. Based on user needs, can provide the gear shaft Hole annex.